The steering angle sensor is a very important component of the car. These days vehicles come with many build sensors. More and more focus is on these sensor settings and all. One such big problem is setting the steering angle sensor without a scanner. It is a typical task but it is not impossible. Here is the guide on how to reset the steering angle sensor without a scanner.
This guide will help you to do the resetting of the steering wheel sensor. It is hard but with the right guidance and tools, you can do this in no time. So if you are looking for ways to do this then you are at the right place.
Table of Contents
Basics About Steering Angle Sensor
Before diving into any processor, you should understand the basics of the steering angle sensor. The steering angle sensor monitors the position of the steering wheel and helps the vehicle’s onboard computer determine the appropriate response for stability control, traction control, and other safety systems.
Over time, factors like a dead battery, wheel alignment changes, or even simple wear and tear can lead to the need for a reset.
Steps For How To Reset The Steering Angle Sensor Without A Scanner
Here are the steps that one has to follow to set this sensor. Make sure that you follow these as it is for the resetting process.
If you skip a step then complications will happen and the damage to the sensor is most likely to happen. So try to follow these as they are written.
- The first thing you have to do is park the vehicle in the shaded area. And then turn off the vehicle. Because safety comes first.
- Now turn the steering totally to the left. And hold for a few seconds.
- And then turn the steering to the right and then hold the position for a few more seconds.
- Now straighten the steering wheel and then hold this position for a few seconds.
- And then wait for 15 minutes and then restart the vehicle. Then the steering angle sensor will reset.
Another Way To Reset The Steering Angle Sensor Without A Scanner
The above one was the easiest way to do this process but there are other ways to do this as well. Here is that way and you can use this as well to get the best possible results.
- For this method, all you have to do is disconnect the battery.
- And then wait for 30 minutes.
- Then reconnect the battery and start the vehicle.
- This will help in the resetting process.
It is the most hassle-free way to do this. Make sure that you attach the wires in the right way.
Considering Matters While Resetting The Steering Angle Detector
While this DIY system is a cost-effective way to reset the steering angle detector without a scanner, it may not be suitable for all vehicles or complex issues. However, it’s judicious to seek professional help, If problems persist or if your vehicle has fresh warning lights or issues.
Also, keep in mind that this system focuses on resetting the steering angle detector and may not address underpinning issues that could affect your vehicle’s safety and performance. However, consult with a good handyperson or your vehicle’s manufacturer for guidance, If you’re doubtful or uncomfortable performing this procedure.
Conclusion
In conclusion, Here is how to reset the steering angle sensor without a scanner. There are various ways to do this process. The methods can be different but the final result will be the same. If you’re choosing the battery disconnecting way then you have to remain a little careful with the wires. The first method is the easiest one. ]
]Some people complain that the first method is not working with their vehicle. Then the problem might be in the parking space. You have to ensure that you’re parking the vehicle on a flat surface.
If the surface is unstable then you will face problems in resetting the sensor. Also, make sure that you wait for enough long. Do not hurry to restart the vehicle. Wait as long as you can.
See Also…
How To Trick A Mass Air Flow Sensor {Help Guide}(Opens in a new browser tab)
